Zydus Pharm Morphine Er (IV PREP???) Imprint N 30 pink 30mg ER

[Tainted (OP)]

Has anyone ever gotten zydus pharmaceutical morphine??? The 30mg pills are pink, oval/oblong, say N on one side, 30 on other (theyare NOT m boxes/malli)

My dealer got abg and N30s, I'm gonna swing thru and buy both, but I'm curious about these N30s. They are ER I think buy Google isn't returning much on them. My dealer don't fuck with opiates herself, but she said her ppl have shot the N30s and said there better than the abg. I don't wanna go spend money and get thirty if them if you need to cook them or prep like endo or malli, abg are so easy to shoot and stronger than endo or malli, but if these are easier or stronger than abg, I don't wanna buy all thirty abg. Anyone ever seen these???

[Thoms]

Never seen em. I would just stick (spike) to what i know. Abg

[Tainted (OP)]

Never seen em. I would just stick (spike) to what i know. Abg

Yeah by time I got there she only had the n 30 or malli 30s, so I got the n30s.

She was straight up full of shit. She claimed that her friend said you just have to use an extra spike of water but these things gel up really badly. I was planning on using just cold water like abg, but that didn't work, so I tried cooking it. Was able to get the gel to separate so I slid it off and had clear liquid left. But it wasn't my first shot today and was only a thirty so I dunno if there was even any morph in the shot. My gf is here and has one her tolerance is way lower so when I get that ready she'll be able to tell if it was good or not.


The gel seperated much easier/quicker/at a lower temp then the m box do, so I'm hoping it's better. I haven't tried doing the boil drop method and will prolly just stick to cooking the water and morph together and separating it long before it boils (the way I do m box is cook water to boil THEN pour morph in, cook it a little more with very little heat to keep it from boiling, once it looks right I spray fifty units of cool water in, throw the cotton in and suck it up. Not a good as an abg, but it gets me well and if I'm sick I'll get an okay rush off a thirty.... But since I have so few of these I'm hesitant to try this method on this new pill)

[Faded]

I recently found a source for Zydus 60's (oval, N 60's) for $2/each or cheaper... Grabbed a couple just for the hell of it to give it a try, and standard prep practices do not work at all. Pill gelled up so bad as soon as it touched water that I could literally turn the spoon upside down and the glob stuck to it.

If anyone comes across these and has a tek that works I will gladly try at the price I can get them for...

[Tainted (OP)]

I recently found a source for Zydus 60's (oval, N 60's) for $2/each or cheaper... Grabbed a couple just for the hell of it to give it a try, and standard prep practices do not work at all. Pill gelled up so bad as soon as it touched water that I could literally turn the spoon upside down and the glob stuck to it.

If anyone comes across these and has a tek that works I will gladly try at the price I can get them for...

Try taking the coating off it, throwing in 200 units of water and the powder. Cook the spoon, but do it slowly (don't keep the flame really close, keep the spoon a little bit above it, make sure that it doesn't start boiling or even get close to boiling) eventually, the powder will separate from the water (you can tell when it does it kind of clumps up and very easily you can use the orange cap to knock the gel off the spoon) throw cotton in suck up, should get about 70 units (if you get significantly less than try using 250 units water)

The risk with cooking is getting it too hot. You get it too hot and your gonna end up with a shot of water with 20%of the morphine, at MOST.

That's the technique I used. I'm going to post below the technique I got from opiophile for doing the malli morph, I'm guessing it'll work for these zydus pills.

1. Take the coating off of the MS Contin. I usually put it in my mouth and suck until it is white and then take a cloth or sock and dry it really good. Perhaps put a fan over it for a minute or so to get it super dry.
2. Take a Time magazine cover (or similar, I use a Playboy centerfold  ) or a mortar and pestle and grind the pill until it is nothing but powder. If you use a magazine cover, use a hammer or similar blunt object and hammer or crush until super fine. The finer the better.
3. Make sure you have a cooker, syringe and needle, cottons, and of course water. I wish I had access to wheel filters, but I don't. If you do, I would highly suggest you use them.
4. Take 1cc of water per pill, and put it in the cooker. Put .5cc to the side for later use.
5. Using a Zippo or candle (or even a bic if you want to burn your fingers) heat the water until just boiling.
6. Immediately take the powder from the pill and pour it in.
7. Add the .5cc of room temperatur water evenly to the mix
8. Heat again until the wax turns a pale white. Don't boil it again.
9. If you can, push the wax to the side of the cooker, or
10. Throw in the cotton. Put the needle/syringe in and pull back until you get all of the water out of the mix. There should only be wax left.
11. If you want, you can heat the wax and you can get a little bit more water out of it, but not a significant amount.
12. I think you know what to do from here.

[Thoms]

Yeah try the boil and drop i hope it works. We always use 3 ml barrels. I take mine using 2.5 ml up to 150 mg then we go to 6 ml if we get deep in a run.

[Thoms]

Did you boil and drop? we got fucked with them now

[Tainted (OP)]

Did you boil and drop? we got fucked with them now

Boil drop only works on endo I thought? I haven't tried for malli or n30, but didn't think it would work.

[Thoms]

Tshe is going to try it with the n30s we just got im at work fml

[Tainted (OP)]

Tshe is going to try it with the n30s we just got im at work fml

Do you do the boil drop on the malli??? I have a bunch of m30s right now but I don't wanna risk throwing a cotton down and it not working, dunno if id be able to salvage so I don't wanna risk it

[Andi]

Yeah, I just did the boil and drop. No gelling at all and all that seems to be left in the cooker is the coating and a little residue.

I did 1 1/2 or 45 mgs and used 3 ml of water. That was plenty. I got back 2.5 roughly. If you're using just a 1 ml rig, I'd say 1 ml maybe even a few extra units would be plenty. But it's been so long since I've used a barrel smaller than 3 ml, I could be wrong. The rush and high doesn't seem to different than the abg. In fact, if I wasn't a lazy fucker, I'd prefer these. But I hate heating shit up.
 

[Thoms]

Tshe is going to try it with the n30s we just got im at work fml

The only other 30s ive done the drop and boil are on the green thirties. Andi can answer better than me. Im fucking excited that shit worked. Im pounding waters to fattin these tubes up now:)

Do you do the boil drop on the malli??? I have a bunch of m30s right now but I don't wanna risk throwing a cotton down and it not working, dunno if id be able to salvage so I don't wanna risk it

[Thoms]

Oops buy em all if they are cheap! Boil then drop for the mother fucking when. Just use lots o watta and they are fiya!

[Kitkat]

They do need to be cooked but no need for Epsom salt like the others and they break down fast

[Tainted (OP)]

They do need to be cooked but no need for Epsom salt like the others and they break down fast

you've responded to like every morphine thread, but i haven't found epsom salt to be neccessary for any brand of morphine, and ive done either brand in existance, or 95% of them. I've read that it works, frmo other people online, but it's never worked for me on any pill (like abg)