Prepping Opana ER for IV

[OCKfromthePhile (OP)]

So I was able to obtain some 40mg opana ERs for $5 a piece.

They are the new formulation, and the ones I have have a 40 on one side and and E on the other, and are kind of a light yellowish in color.

I have read conflicting reports on how to prep these for IV, and if it can even be done.

I wish opiophile was still online right about now.

Please, someone chime in, point me in the right direction, or something.

I am getting sick, and have 10 of these to do something with.  I know eating them is next to a waste.

Can these be crisped?  If so, how, exactly, is it done?

Can I just soak in alcohol for 12 or so hours and then inject the remaining liquid?

These are basically crush proof, and take a Hella long time to grind up.

I have popped a few, in hopes to subside the withdrawals long enough until I can find an IV tek I trust.

And since Opiophile is down, you guys are the only ones I will take advice from when it comes to something like this.

Any information at all is helpful and more than welcome.

[OxyOpanaAlphaOmega]

PLEASE DO NOT INJECT THESE! they can cause an user to develope an illness called thrombocytopenia purpura
Without going into details of the studies it is very very dangerous and CAUSED directly from IV opana ER

the only thing I've heard to do with with is the grind them with a dremel tool in a large bowl and sniff the dust you create with that!
I know how worthless, the ONLY thing I could think of is this: if I didn't have a dog nail file tool or a dremel
I would soak them in coke (small amount like 10mL) and leave it there for 12 hours and plug that solution
I don't know if this works
I've never done it
I do know that the original 91% ISO extraction, DOES NOT WORK on the impax opana, I'm sorry to say
I also do not believe the can be crisped but maybe they can, but remember don't IV them at all!
You got them very cheap so take them orally, I've heard you cut them with razor and leave them in your mouth for a long while they disolve
I'm sorry looks like the new opana they finally got the abuse proof right

Take care
Be smart it's not worth the High to try to IV
ooao

[Tainted]

yeah ill second don't IV them. i had E 15's and honestly I don't even know how people managed to IV them (and i had opiophile to give me several methods to try)  you cannot crush those fucking things. i ended up dremmeling a cpl of them and snorting them and getting nothing, but i will say i tried ISO and everything i could think of to try and shoot them (despite the warnings about ppl getting nasty blood clotting disorders from them) and i was not able to get a usable shot. dont waste your time trying

[jdub]

Do you guys think these take the cake for "most worthless reformulation"?

OP's seem like a dream in comparison. Could just be b/c oc is way more active orally.

[hooley]

proven way to iv opana and have crystal clear shots
   Supplies- 2-1 cc syringes
epsom salt
dremel w/ a grinding bit
needle nose pliers
bench vise
pills to use
rag or shirt( to help remove coating)
spoon or other cooker
32 0z styrofoam cup

1) prep opana pills by sucking on them from 20-45 seconds, removing frequently and rubbing off the outer coating
2)once coating is removed, place pill in bench-vise or pliers and proceed to flatten the pill as much as possible (this will aid in grinding later)
3) de-attach the grinding wheel from dremel and use the base to poke a hole in the bottom of the cup, leaving the grinding wheel inside the styrofoam cup, and the base of the dremel on the cups underside.
4) grip your flattened panda in your needle nose pliers and turn on the dremel to high speed
5) insert pliers and pill into cup and begin to shave the pill with the grinding zone.
6)after pill is fully ground remove the grinding wheel and empty the contents of the styrofoam cup onto a dark colored plate or material ( i prefer a dark colored plate because it makes seeing all of the ground material much easier.

AT this point you can take the finely ground powder and mix it with either tylenol or benadryl and snort the mixture, which produces a pleasant high as oxymorphone's bio-availability inter-nasally is much higher then other R.O.A's besides IV'ing. The adding of the Benadryl or Tylenol helps prevent gelling in the nose and makes insuffilation much more enjoyable. ( sidenote: if snorting do smaller lines that stick in your nasal cavity as not to cause a drip, all drips enter your stomach and then are processed through first pass enzymatic function in the liver, as well as all other oral r.o.a's)

7) if iv'ing the mixture prepare 125ml of fresh water in your rigs ( this will be used momentarily)
after placing the desired amount of powder in the spoon sprinkle with roughly the same amount of epsom salt. (this will help defeat the tamper resistant matrix)
9) add 125 ml water and begin to heat the mixture till the water is simmering.
10) at this point remove from heat and begin to mix up all the pill gunk and water together to properly wash the oxymorphone out of the powder.
11) push all of the pill gunk aside and your left with a nice crystal clear shot of oxymorphone, with a few possible extra washes left in the pill goo.
12) hit a sweet spot and nods away

there is another method as well that may provide slightly better results but i will only discuss them through p,

best of luck,
Hooley

[theSWPK]

That method is for the older formulations or current new generics using said formulation.

Best method for the tamper proofs is to plug them in a solution.

[Daughter of Dionysus]

proven way to iv opana and have crystal clear shots
   Supplies- 2-1 cc syringes
epsom salt
dremel w/ a grinding bit
needle nose pliers
bench vise
pills to use
rag or shirt( to help remove coating)
spoon or other cooker
32 0z styrofoam cup

1) prep opana pills by sucking on them from 20-45 seconds, removing frequently and rubbing off the outer coating
2)once coating is removed, place pill in bench-vise or pliers and proceed to flatten the pill as much as possible (this will aid in grinding later)
3) de-attach the grinding wheel from dremel and use the base to poke a hole in the bottom of the cup, leaving the grinding wheel inside the styrofoam cup, and the base of the dremel on the cups underside.
4) grip your flattened panda in your needle nose pliers and turn on the dremel to high speed
5) insert pliers and pill into cup and begin to shave the pill with the grinding zone.
6)after pill is fully ground remove the grinding wheel and empty the contents of the styrofoam cup onto a dark colored plate or material ( i prefer a dark colored plate because it makes seeing all of the ground material much easier.

AT this point you can take the finely ground powder and mix it with either tylenol or benadryl and snort the mixture, which produces a pleasant high as oxymorphone's bio-availability inter-nasally is much higher then other R.O.A's besides IV'ing. The adding of the Benadryl or Tylenol helps prevent gelling in the nose and makes insuffilation much more enjoyable. ( sidenote: if snorting do smaller lines that stick in your nasal cavity as not to cause a drip, all drips enter your stomach and then are processed through first pass enzymatic function in the liver, as well as all other oral r.o.a's)

7) if iv'ing the mixture prepare 125ml of fresh water in your rigs ( this will be used momentarily)
after placing the desired amount of powder in the spoon sprinkle with roughly the same amount of epsom salt. (this will help defeat the tamper resistant matrix)
9) add 125 ml water and begin to heat the mixture till the water is simmering.
10) at this point remove from heat and begin to mix up all the pill gunk and water together to properly wash the oxymorphone out of the powder.
11) push all of the pill gunk aside and your left with a nice crystal clear shot of oxymorphone, with a few possible extra washes left in the pill goo.
12) hit a sweet spot and nods away

there is another method as well that may provide slightly better results but i will only discuss them through p,

best of luck,
Hooley

Snorting Tylenol isn't really a great idea
Neither is snorting benadryl

[jdub]

That method is for the older formulations or current new generics using said formulation.

Best method for the tamper proofs is to plug them in a solution.

Anyone have experience in epsom salt vs. iso extraction of the new generics? Might be worth its own thread, but I've love to hear if any of you have done both and what you prefer and why.

[Thoms]

Yeah j dub he is talking the trf opanas not the nice new generics. New generic ones are a dream and can be prepped like any easy as pie pill.

[hooley]

No i use this method on the new endo bio-convex opanas, it works great. i just ran through 10 30's

[Tainted]

That method is for the older formulations or current new generics using said formulation.

Best method for the tamper proofs is to plug them in a solution.

Anyone have experience in epsom salt vs. iso extraction of the new generics? Might be worth its own thread, but I've love to hear if any of you have done both and what you prefer and why.

ive tried iso extraction, ive tried cooking the gel/water without salt as well and got a spoon of unusable snot, but i haven't tried adding salt into the mix. it didnt seem like there was any point since they seem so dramatically different from the mscontin's and i wasn't getting remotely close to something usable

[jdub]

Yeah j dub he is talking the trf opanas not the nice new generics. New generic ones are a dream and can be prepped like any easy as pie pill.

No the new generic ER's (global pharma) require an iso or epsom salt extraction. The IR's are the really easy one's

[jdub]

That method is for the older formulations or current new generics using said formulation.

Best method for the tamper proofs is to plug them in a solution.

Anyone have experience in epsom salt vs. iso extraction of the new generics? Might be worth its own thread, but I've love to hear if any of you have done both and what you prefer and why.

ive tried iso extraction, ive tried cooking the gel/water without salt as well and got a spoon of unusable snot, but i haven't tried adding salt into the mix. it didnt seem like there was any point since they seem so dramatically different from the mscontin's and i wasn't getting remotely close to something usable

I'm reasonably happy with the iso extraction, but I saw a vid on reddit of the epsom salt method, and it looked a little bit easier. Just wondering if the end results are similar in effect.

[hooley]

the reddit iso extraction was in response to a question i had posted about when i got the new opana, the Epsom salt is the only 100% percent method that i have for the extraction, because the epsom salt prevents the gel matrix from forming. there is a method that combines the epsom salt and the crisping method, that i have had great success wtih and never once was left with a jelly mess.

[TheSoundsOfScience]

jdub do you have a link to that epsom salt video?  I'm gunna try out the iso extraction tonight on some Global Pharm and some Actavis ones.  I pretty much stopped buying opana because my tolerance got to the point where it was pointless because snorting the amount I needed just made my nose a mess of congealed gel.  Think I might start getting them on the regular again though if this works out.

One question though - I assume it's possible to cut up the resultant product from the extraction to snort it, correct?  I've tried shooting a couple of times, but it's so hard for me to hit a vein having never done it before and I don't have any friends who shoot up in the Bay.